Eicon Networks S93 Installationsanleitung PDF herunterladen (Seite 95)

Installation in Unattended Mode 95

The default value is ‘0 (automatic)’ and this works in most environments. In a few parts of

the ISDN, automatic processing of the CRC4 is not implemented and requires a special

setting.

Specific parameters for RBS T1

RBSStart

RBSStart specifies which trunk type is used with the RBS T1 protocol. The trunk type

specified here must correspond to the trunk type that your switch uses.

Possible settings are:

• 0: for Wink Start

• 1: for Loop Start

• 2: for Ground Start

The default value is ‘0’.

Note: All trunk types are defined in the TIA/EIA-464B specification; Wink Start is also

defined in AT&T TR41458.

RBSDial

RBSDial specifies which dial type is used with the RBS T1 protocol. The dial type selected

here must correspond to the dial type that your switch uses. Possible settings are:

• 0: for Pulse

• 1: for DTMF (Dual-Tone Multifrequency Signaling)

• 2: for MF (Multifrequency Signaling)

The default value is ‘1’. Most analog telephones use dual-tone multifrequency signaling.

RBSBearerCapability

RBSBearerCapability (RBS Bearer Capability) specifies which bearer capability should

be included with the incoming call that is signaled to the application. Possible settings are:

• 4 (Voice/Analog): Select this value if your application is meant to accept voice calls, fax

group III calls, and analog modem calls.

• 8 (Data/Digital): Select this value if you application handles digital calls, e.g. digital RAS.

The default is ‘4’.

Note: If your switch can support only voice or data calls at one time, make certain that it

is configured to correspond with the ‘RBSBearerCapability’ value.

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 129 130

Keine Kommentare

Eicon Networks S93 Installationsanleitung Seite 95