Eicon Networks S93 Installationsanleitung PDF herunterladen (Seite 30)

WAN-Miniport driver 30

4. Enter the corresponding MSN or EAZ in ‘Phone number’.

5. If required, enter the corresponding subaddress in ‘SUB’.

6. Click ‘OK’.

Advanced Settings

Select the ‘Advanced Settings’ page if the following parameters need to be configured:

Accept Analog Calls

Leave this option enabled if analog calls are also to be accepted.

Note: If there are other devices on the same bus, such as a telephone or fax, and the

WAN Miniport has not been assigned a special MSN, this option may cause problems. In

this case, the WAN Miniport may answer incoming calls intended for the other devices.

B-Channel Protocol (incoming)

This parameter is only available if exclusively Diva Server 2.0 adapters are installed in

your system. Normally, the WAN Miniport detects the B-channel protocol of incoming calls

automatically and the default setting ‘Automatic detection’ may stay unchanged. However,

the Chinese PIAFS B-channel protocol cannot be auto-detected.

If incoming calls use this protocol, you must specify the appropriate PIAFS version:

• PIAFS (China, fixed speed):

Select this option if the PIAFS B-channel protocol of your incoming calls uses a fixed

transfer rate, either 64 kbps or 32 kbps.

Select the appropriate transfer rate under ‘B-Channel Protocol Speed’, either ‘32000’

or ‘64000’.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 129 130

Keine Kommentare

Eicon Networks S93 Installationsanleitung Seite 30