Eicon Networks S93 Installationsanleitung PDF herunterladen (Seite 101)

Installation in Unattended Mode 101

UsEktsFeatCallTransf

The ‘Call Transfer’ feature allows you to connect two calls and disconnect yourself from

the call. Set the command code value that activates this feature for your switch type. Your

ISDN service provider can supply the required information.

Possible values are 0x00 to 0xff.

UsEktsFeatMsgWaiting

The ‘Message Waiting’ feature indicates if the voice mail system has recorded a message.

Set the command code value that activates this feature for your switch type. Your ISDN

service provider can supply the required information.

Possible values are 0x00 to 0xff.

ForceAlert

ForceAlert specifies how incoming calls are handled when no application is active.

• 0 (off): When a call comes in while no application is active or the computer is being

restarted, the Diva Server adapter sends a DISCONNECT message and the call is

disconnected without being forwarded to the voice mail system.

• 1 (on): When a call comes in while no application is active or the computer is being

restarted, the Diva Server adapter sends an ALERT message and the voice mail

system answers the call instead of it being disconnected immediately.

Common components section

WAN-Miniport driver section

The WAN Miniport can be installed using the default parameters, which means that no

parameters are defined for the ‘WAN’ section. However, if you need to change the default

settings, you can modify the following parameters.

Note: To run the WAN Miniport properly, Microsoft Remote Access Service must be

installed.

AuthProtocol

This option specifies whether only RAS authentication ‘0’ is used or also Security

Dynamics authentication ‘1’. The default is 0. Note that, if Security Dynamics

authentication is selected, the Eicon Authentication Service must be installed.

AuthTimeout

The ‘Authentication Timeout’ parameter only applies if Security Dynamics is selected as

the authentication protocol. The parameter specifies the maximum time (in seconds) that

the WAN-Miniport driver will wait for an authentication result. Any value between 2 and

10 seconds is allowed. The default is 3 seconds.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 129 130

Keine Kommentare

Eicon Networks S93 Installationsanleitung Seite 101