Eicon Networks S93 Installationsanleitung PDF herunterladen (Seite 105)

Installation in Unattended Mode 105

Fixes

Fixes specifies the settings of the parameters ‘Allow callback’, ‘Support calls with

synchronous PPP’, and ‘Accept analog calls’. Enter here the sum of the parameter values

plus the value 168. The parameter values are as follows:

• 1 (Allow callback): If you want the Port driver to support RAS callback, add the value

‘1’ to the ‘Fixes’ value. In the RAS callback scenario, the remote user is automatically

disconnected after authentication and then called back. The Port driver registers the

properties of the incoming call and applies the same properties to the outgoing callback.

• 2 (Support calls with synchronous PPP): If the Port driver should accept incoming calls

with synchronous PPP (ISDN-specific framing method used by ISDN networking

products), add the value ‘2’ to the ‘Fixes’ value. By default, the Port driver can only be

used for incoming calls from asynchronous devices.

• 16 (Accept analog calls): If the server should accept calls from analog remote devices,

add the value ‘16’ to the ‘Fixes’ value. This parameter should be enabled in most cases.

Example: If you want the Port driver to support RAS callback and accept analog calls but

you do not want it to accept incoming calls with synchronous PPP, enter the value ‘185’.

CallbackTimeout

CallbackTimeout specifies the interval in seconds after which the incoming call properties

are deleted from the Port driver if no callback has been established. When the callback

timeout has expired, the callback cannot be established any longer. Any value between 0

and 999 seconds is allowed.

The default is 30 seconds.

Example of the Port-driver section

[MODEMS]

Logging=0

FirstPort=5

Fixes=185

CallbackTimeout=35

CAPI driver section

The CAPI driver can be installed with default parameters which means that no parameters

are defined in the ‘CAPI’ section. However, if you need to change the default settings, you

can modify the following parameters:

Logging

Logging specifies the level of traces. Possible settings are:

• 0: for error traces only

• 1: for standard tracing

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 129 130

Keine Kommentare

Eicon Networks S93 Installationsanleitung Seite 105