Eicon Networks S93 Installationsanleitung PDF herunterladen (Seite 22)

Basic drivers 22

• Specify if the adapter should generate internal ring tones when they are not provided

by the switch or PBX.

• Specify if your adapter is operated in a hunt group or used as monitoring device.

For detailed explanations of the ‘Advanced Settings’, see the online help (‘Help’ or ‘F1’).

ISDN Protocol Settings

The ‘ISDN Protocol Settings’ tab contains parameters for configuring the protocol

software. Specific information on the ISDN, Q-Sig, or RBS T1 protocol is requested here.

These parameters can usually remain at their standard values.

Note: With a Diva Server 4BRI or Voice 4BRI adapter, the ‘ISDN Protocol Settings’ must

be specified individually for each of the four controllers (controller [1] to controller [4]).

Select ‘[<controller number>] ISDN Protocol Settings’ for each of them.

Specifics of all Diva Server PRI and Diva Server Voice PRI adapters

Note: Not all of these parameters are available with the Q-Sig or RBS T1 protocol.

The following values must be set for primary rate adapters (PRI):

•‘TEI’ must be set to ‘TEI 0’.

•‘Connect Mode’ must be set to ‘Permanent’.

These values should be changed only on instruction of the ISDN provider.

Detailed explanations of the parameters can be found in the online help (‘Help’ or ‘F1’).

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 129 130

Keine Kommentare

Eicon Networks S93 Installationsanleitung Seite 22