Eicon Networks S93 Installationsanleitung PDF herunterladen (Seite 41)

Eicon Port driver 41

Eicon Port driver

Diva Server for Windows NT provides the Eicon Port driver, i.e. virtual COM port, for

modem emulation. It behaves in the Windows NT system like a serial interface with a

connected modem.

The virtual COM port allows you to install virtual TAPI modems for a variety of connections:

fax, V.110, V.120, HDLC, X.75, or analog modem. Thus, with Diva Server for Windows NT

you can send and receive faxes, access ISDN mailboxes or communicate with analog

modems.

To make use of modem emulation, you first have to install the Eicon Port driver. Then, you

can configure the Port driver and select the desired number of serial COM ports in the

‘Eicon Port Driver Setup’. After the installation process of Diva Server for Windows NT is

complete and you have restarted your computer, you can install and configure the virtual

modems that are to use the COM ports; see Installing virtual modems

on page 59 for

more information.

If the Port driver has already been installed, see Configuring the Eicon Port driver

page 42 for more information.

Installing the Eicon Port driver

Install the Eicon Port driver as follows:

1. Click ‘Start > Run’.

2. Type the path to the installation file:

• Insert your Diva Server CD-ROM and enter the following path:

D:\DRIVER\WINNT\ENGLISH\SERVICE\SETUP.BAT

(where D: is your CD-ROM drive letter).

• Or enter the path to the installation file on the hard disk, e.g.:

C:\ISDN\SERVICE\SETUP.BAT

(where C: is your hard disk letter).

Click ‘OK’.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 129 130

Keine Kommentare

Eicon Networks S93 Installationsanleitung Seite 41