Eicon Networks S93 Installationsanleitung PDF herunterladen (Seite 81)

Using Security Dynamics Authentication 81

Eicon Authentication Service

If the Security Dynamics authentication has been configured in the WAN-Miniport driver,

the Eicon Authentication Service still has to be installed. You will be prompted when the

network configuration is complete. Click ‘Ye s ’ in the appropriate dialog box to confirm.

Finally, the ‘Eicon Authentication Service Setup’ dialog box will appear:

Enter the IP address of the ACE/Server and the required password. If there is a backup

server available, configure an IP address and password for the backup server also.

Finally, click ‘OK’ to confirm.

Start or stop authentication service

The authentication service can be stopped and restarted manually to investigate error

functions.

If the service is restarted from the command line, the service will not run in the background,

but in a DOS window, and therefore will show its status information on screen. Thus, you

can see whether the ACE/Server has given a positive (green) or negative (red) answer to

the access logon before the WAN Miniport detects this information.

To start the service from the command line, enter:

net start diehl_diauthsv

To stop the service from the command line, enter:

net stop diehl_diauthsv

To view debug information on the screen, enter:

diauthsv -debug

Stop debugging with ‘Ctrl’ + ‘C.’

The authentication service can also be started and stopped from the Control Panel using

‘Services.’

Select ‘Eicon Authentication Service’ in the ‘Services’ dialog box and click ‘Finish’ or ‘Start’.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 129 130

Keine Kommentare

Eicon Networks S93 Installationsanleitung Seite 81