Eicon Networks S93 Installationsanleitung PDF herunterladen (Seite 92)

Installation in Unattended Mode 92

ForceLaw

ForceLaw specifies which voice coding is used. Voice coding defines how voice data are

transmitted over the ISDN. Possible settings are:

• 0 (Protocol Default): Voice coding is used as specified in the respective switch type

standard specification.

• 1 (Force a-law): a-law is generally used in Europe

• 2 (Force µ-law): µ-law is generally used in North America.

The default value is ‘0’. This automatically sets the correct voice coding for the selected

switch type.

In most cases you can leave ForceLaw at its default value. Only if your PBX requires a

special voice coding that does not correspond to the voice coding of the switch type, you

need to change the setting.

GenerateRingTone

For NT-mode or point-to-point connections only. Normally, ring tones are generated by the

switch or PBX. If the switch or PBX do not provide busy or alert tones for incoming calls,

set ‘GenerateRingTone’ to ‘1’ to enable the Diva Server adapter to generate these tones

locally.

• 0 (off): Do not generate tones.

• 1 (on): Generate tones locally.

FractionalLine

FractionalLine (Fractional T1/E1 Line) is only used for Diva Server PRI adapters. Specify

if you use a fractional E1 or T1 line, i.e. an ISDN PRI or channelized T1 line with a reduced

number of B-channels. Possible values are:

• 0 (off): A full E1 or T1 line offering 30, 23, or 24 channels is used.

• 1 (on): A fractional E1 or T1 line is used.

Channels

Channels (Number of B-Channels) can only be used if FractionalLine is set to ‘1’. Specify

the number of B-channels that your fractional E1 or T1 line provides. Possible values are

‘1’ up to ‘29’ for all switch types except North American ones, ‘1’ up to ‘22’ for all North

American switch types except RBS T1, and ‘1’ up to ‘23’ for RBS T1.

LowChannel

LowChannel (Lowest B-Channel) can only be used if FractionalLine is set to ‘1’. Specify

the lowest B-channel that is assigned to your fractional E1 or T1 line. The ISDN service

provider can supply the required information.

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 129 130

Keine Kommentare

Eicon Networks S93 Installationsanleitung Seite 92