
Across the Boards
Communications Device Drivers
Section 6 - MAINCON Driver Configuration
Page 246
cfSOFTWARE Confidential,
2000
6.15 MAINCON Panel D2, IBM 3101 (continued)
These panels define what is sent to the host when the 3101 terminal is used for 3270 emulation. Each entry
defines the sequence sent for a single 3270 key. For example, the 3270 protocol converter attached by the host
may be configured to emulate the 3270 Clear key function when it receives the sequence Esc L. To configure
that sequence, enter ESC and L in the first two fields for the CLEAR entry in the table.
A sequence of up to 4 characters may be entered for each key definition. Only one character may be entered in
each field.
NOTES
:
It is possible to redefine the normal printable character keys as well as the 3270 control and function
keys, (for example, the A key could be redefined), but this should almost never be done.
Each field may be coded.
See Section 7.5 MAINCON ASCII Characters
.
BRK may be coded as the first field in a key definition.
The sequences entered should match the configuration of the protocol converter. This information
should be available from the mainframe System’s Programmer.
For APPX and
pcMAINFRAME
usage, at least the definitions for RESET, ENTER and CLEAR should
be correct.
__________________
ACROSS-THE-BOARDS(r) Config
__________________
Page 2 of 6
IBM 3101 - ASCII Key Values
----3101---- -----PC ASCII------ ----3101---- -----PC ASCII------
ENTER CR PF16
PF1 ESC 1 PF17
PF2 ESC 2 PF18
PF3 ESC 3 PF19
PF4 ESC 4 PF20
PF5 ESC 5 PF21
PF6 ESC 6 PF22
PF7 ESC 7 PF23
PF8 ESC 8 PF24
PF9 PA1 BRK
PF10 PA2
PF11 PA3
PF12 CLEAR ESC L
PF13 SYSREQ
PF14 TEST
PF15 ATTN
F10:write config Esc:Exit PgDn:next page PgUp:prior page F1:help F3:5250
Kommentare zu diesen Handbüchern