
Across the Boards
Communications Device Drivers
Section 6 - MAINCON Driver Configuration
Page 300
cfSOFTWARE Confidential,
2000
6.23 MAINCON Panel E3
DECNET VT220
Configuration filename: MAINCFG.DN2
Used by cf Device Drivers:
#
Name Description
51 CFXDN22 DECNET/Pathworks VT220
As of 10/26/93, these drivers are only available in the Windows environment.
__________________
ACROSS-THE-BOARDS(r) Config
__________________
Page 1 of 14
--- Protocol Converter (DECNET VT220) ---
Autowrap (0 or 1)....................... 0
Reset needed after BELL? (0=No, 1=Yes).. 0
Flicker check time (in 100ths second)... 0
Half duplex (0 OR 1).................... 0
Trace size in K bytes................... 0
DECNET Connection Type.................. 0
0: Data does not wrap to next line when the margin is reached. 1: Data wraps to
the next line when margin is reached.
F10: write config to disk Esc: Exit PgDn: next config menu
1. Autowrap
When set to ‘1’, this switch causes the cursor to wrap to the beginning of the next line automatically when
the last position in a line is written to by the protocol converter.
2. BEL Reset
If the protocol converter locks the keyboard after sending a BELL character, setting this switch to ‘1’ will
cause a RESET key sequence to be sent after receiving a BELL. The RESET key is defined in the 3101
KEY TABLE.
3. Flicker
Controls how much extra time (in 100ths of a second) will be spent waiting to insure that the protocol
converter has stopped sending data.
4. Half-Duplex
Setting this field to ‘1’ will cause the VT220 emulator to operate in half-duplex mode. Half-duplex mode is
significantly inferior to full-duplex mode for terminal emulation and data transfer. Full-duplex mode should
be used where ever possible.
Kommentare zu diesen Handbüchern