Eicon Networks CX1 Spezifikationen PDF herunterladen (Seite 108)

Across the Boards



Communications Device Drivers

Section 6 - MAINCON Driver Configuration

Page 258

cfSOFTWARE Confidential,



2000

6.17 MAINCON Panel D4, Tymnet78 (continued)

NOTE

: The key definitions for the Tymnet78 driver should not normally be changed from the defaults.

These panels define what is sent to the host when the VT220/VT320 terminal is used for 3270 emulation. Each

entry defines the sequence sent for a single 3270 key. For example, the 3270 protocol converter attached by the

host may be configured to emulate the 3270 Clear key function when it receives the sequence Esc L. To

configure that sequence, enter ESC and L in the first two fields for the CLEAR entry in the table.

A sequence of up to 32 characters may be entered for each key definition. Only one character may be entered in

each field.

NOTES

It is possible to redefine the normal printable character keys as well as the 3270 control and function

keys, (for example, the A key could be redefined), but this should almost never be done.

Each field may be coded.

See Section 7.5 MAINCON ASCII Characters

BRK may be coded as the first field in a key definition.

The sequences entered should match the configuration of the protocol converter. This information

should be available from the mainframe System’s Programmer.

For APPX and pcMAINFRAME usage, at least the definitions for RESET, ENTER and CLEAR

should be correct.

__________________

ACROSS-THE-BOARDS(r) Config

__________________

Page 2 of 6

TYMNET78 - ASCII Key Values

--TYMNET78-- -----PC ASCII------ --TYMNET78-- -----PC ASCII------

ENTER CR PF16 ^B @ CR

PF1 ^B 1 CR PF17 ^B ! CR

PF2 ^B 2 CR PF18 ^B “ CR

PF3 ^B 3 CR PF19 ^B # CR

PF4 ^B 4 CR PF20 ^B $ CR

PF5 ^B 5 CR PF21 ^B % CR

PF6 ^B 6 CR PF22 ^B & CR

PF7 ^B 7 CR PF23 ^B ‘ CR

PF8 ^B 8 CR PF24 ^B ( CR

PF9 ^B 9 CR PA1 ^B ) CR

PF10 ^B : CR PA2 ^B * CR

PF11 ^B ; CR PA3 ^B + CR

PF12 ^B < CR CLEAR ^C CR

PF13 ^B = CR SYSREQ ^Y CR

PF14 ^B > CR ZAP-CIRCUIT ^K CR

PF15 ^B ? CR ATTN ESC : CR

F10:write config Esc:Exit PgDn:next page PgUp:prior page F1:help

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 231 232

Kommentare zu diesen Handbüchern

Keine Kommentare

Eicon Networks CX1 Spezifikationen Seite 108

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Eicon Networks CX1