Eicon Networks CX1 Spezifikationen PDF herunterladen (Seite 37)

Across the Boards



Communications Device Drivers

Section 5 - General Configuration and Usage Information

Page 187

cfSOFTWARE Confidential,



2000

5.5 Multiple COMM Port and Modem Server Support (continued)

Configuration for INT 14 is similar to the preceding examples with the following exceptions:

Again, the choice of COMM port is not significant (1-15 may be used).

On the “Communication Port Assignments” configuration screen, specify type “INT14” for the

COMM port you have chosen.

You will then be prompted for a “Port” and a “Dialect”. The Port will be the port number

specified to the INT 14 interface. Usually the INT 14 redirector software (included with the

modem server software) allows the configuration of a particular COMM port to redirect. This is

the port number to configure here. The Dialect field should be set to a non-zero value if the INT

14 redirector software implements one of the supported dialects. The following dialects are

currently supported:

0 - Basic INT 14 API

1 - Fresh Technology/Modem Assist

03/17/93. Reported a problem using MODEM_ASSIST Version 2.1. This new version is structured much

differently than earlier versions we have tested. On the server, you run MSERVER; on the client, MCLIENT

CONNECT.

The problem was that the user was running MCLIENT without the CONNECT parm. In this state, Modem

Assist’s test program, TERM, will run just fine but not the INT 14 interface.

NOTE

: This new release is not compatible with the old extended INT14 dialect 1 (configurable in

MAINCON). Users of this release

must

run basic dialect (dialect 0).

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 231 232

Eicon Networks CX1 Spezifikationen Seite 37