
Across the Boards
Communications Device Drivers
Section 6 - MAINCON Driver Configuration
Page 268
cfSOFTWARE Confidential,
2000
6.19 MAINCON Panel D6, DEC VT220 (continued)
These panels define what is sent to the host when the VT220 terminal is used for 3270 emulation. Each entry
defines the sequence sent for a single 3270 key. For example, the 3270 protocol converter attached by the host
may be configured to emulate the 3270 Clear key function when it receives the sequence Esc L. To configure
that sequence, enter ESC and L in the first two fields for the CLEAR entry in the table.
A sequence of up to 32 characters may be entered for each key definition. Only one character may be entered in
each field.
NOTES
:
It is possible to redefine the normal printable character keys as well as the 3270 control and function
keys, (for example, the A key could be redefined), but this should almost never be done.
Each field may be coded.
See Section 7.5 MAINCON ASCII Characters
.
BRK may be coded as the first field in a key definition.
The sequences entered should match the configuration of the protocol converter. This information
should be available from the mainframe System’s Programmer.
For APPX and pcMAINFRAME usage, at least the definitions for RESET, ENTER and CLEAR
should be correct.
__________________
ACROSS-THE-BOARDS(r) Config
__________________
Page 5 of 14
DEC VT220 ASCII KEY VALUE
---VT220--- ------------------ASCII VALUES---------------------------------
ENTER CR
PF1 ESC 1
PF2 ESC 2
PF3 ESC 3
PF4 ESC 4
PF5 ESC 5
PF6 ESC 6
PF7 ESC 7
PF8 ESC 8
PF9 ESC 9
PF10 ESC 0
PF11
PF12
PF13
PF14
PF15
F10:write config Esc:Exit PgDn:next page PgUp:prior page F1:help
Kommentare zu diesen Handbüchern