Eicon Networks CX1 Installationshandbuch PDF herunterladen (Seite 60)

G&R

-LP local port

myglineapp -li tcp -lp 9999

This parameter selects the local port for incoming connections, and enables

accept of incoming connections. You can use the port number or a symbolic

name. In the latter case this symbolic name must be registered in your services

file. The default is to not accept incoming connections. It defaults to raw mode.

-LU LUname

This is used in TN3270 mode to ask for a specific LU name on the host side.

-NU on/OFF

v78sim -li tcp -nu on

This enables Telnet CRNUL mode. Normally Telnet in ASCII mode encodes a

carriage return (CR) as a Telnet ‘new line’ by appending a line feed (LF). In

this mode a NUL character is appended instead.

-RES resource name

This parameter is used in application mode TNVIP. It selects a non-default

‘mailbox name’, which acts as a special access point in the TNVIP server. It

has a maximum length of 12 characters, and will be appended to the terminal

type (given by the -TM parameter), separated by a delimiter. It is used to select

a specific terminal configuration in the terminal manager.

-RP remote_port

v78sim -li tcp -rp 9998 -am telnet

This selects a remote port for outgoing connections. You can use the port

number or a symbolic name. In the latter case this symbolic name must be

registered in your services file.

The default port number for the Telnet application modes, TELNET, TN3270

and TNVIP is the ‘Telnet’ port number, 23. If you set another remote port the

default application mode is RAW. If you want to use Telnet you must set it.

-SU username

This sets the user name to be used when logging in to the Rlogin server.

Gline Line Handlers and Configuration

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 132 133

Keine Kommentare

Eicon Networks CX1 Installationshandbuch Seite 60