Eicon Networks CX1 Installationshandbuch PDF herunterladen (Seite 37)

G&R

Transport disconnect

‘Transport disconnect received’ errors after a connection attempt typically

mean that you have a physical problem with the link or a network configuration

problem. Look up the error code displayed in the XTI/OSI documentation. If

you are using the Bull OSI-stack on an AIX platform use the pmaderror

command to get the error code explained. Check with trace tools on the UNIX

side if any packets leave the UNIX system. The problem may possibly be on

the other side if transport does not manage to establish connection with the

session layer there. In this case some of the OSI stacks will deliver the X25 or

DSA reason code, in which case see the section entitled Error codes.

Session refused

Session refused or session aborted errors after a connection attempt typically

mean that you have Front-end or mainframe configuration errors, or a mismatch

between the Host Links and Front-end or mainframe configuration.

Look up the error code displayed in the OSI/DSA network system messages

and return codes manual, see the section entitled Error codes or use the

Gerror utility, see section entitled DSA test utilities on page 109.

Parameters for DSA/DIWS handler

The following parameters apply to this handler (defaults in uppercase):

Parameter Description

-LI DIWS

Start gl_dsa in DIWS protocol mode

-LI DSA

Start gl_dsa in DSA protocol mode

-LI DIWS:GATEWAY

Start gl_dsa in DIWS mode through Ggate running

on GATEWAY

-LI DSA:GATEWAY

Start gl_dsa in DSA mode through Ggate running

on GATEWAY

-AM SNM

Application mode GCOS6 SNM

GEN

Application mode general

AST

Application mode Datanet AST

Gline Line Handlers and Configuration

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 132 133

Keine Kommentare

Eicon Networks CX1 Installationshandbuch Seite 37