Eicon Networks CX1 Installationshandbuch PDF herunterladen (Seite 43)

G&R

-BT 1/2/3

This parameter changes the default for the break signal. The default for

DSA200 is ‘Attention 1’ (-BT 1), with ‘Attention 2’ (-BT 2) used in special

circumstances. The default for DSA300 is ‘data attention’ (-BT 3). Data

attention is normally negotiated when needed by the mainframe, and this

parameter is not necessary.

-CM xxxx

qsim -li dsa -cm TWAI

This parameter sets a connection mode to be suggested to the other party when

the connection is initiated. Four connection modes are supported:

TWSI

Two Way Simultaneous Initiators turn. The applications can send

without having 'turn'. The application establishing the session starts.

TWSA

Two Way Simultaneous Acceptors turn. The applications can send

without having 'turn'. The application accepting the session starts.

TWAI

Two Way Alternate Initiators turn. The applications must have 'turn' to

send. The application establishing the session starts.

TWAA

Two Way Alternate Acceptors turn. The applications must have 'turn' to

send. The application accepting the session starts.

By default the handler offers to do both TWS and TWA and leaves the initial

choice of turn to the other end. When Gline receives an incoming connect it

accepts whatever the other end suggests unless you set the -CM parameter.

Gline Line Handlers and Configuration

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 132 133

Keine Kommentare

Eicon Networks CX1 Installationshandbuch Seite 43