Eicon Networks P92 Installationsanleitung PDF herunterladen (Seite 5)

EiconCard P92 Installation Guide 5

Introduction

This guide describes how to install the EiconCard P92 card in any

computer with a PCI-compatible bus.

The EiconCard P92 allows stand-alone PCs or multiple users on a

Local Area Network (LAN) to make very high speed connections to

a Wide Area Network (WAN). These connections are typically made

through the EiconCard P92 to external communications equipment

(including CSUs, DSUs, and synchronous and asynchronous

modems) to provide access to WAN lines. Direct connections to a

host computer or to another EiconCard are also supported.

Hardware Features

The EiconCard P92 features a 10MHz Hitachi 64570 controller and

512 KB of on-board RAM. It has two independent Very High-Speed

Interface (VHSI) ports, supporting full duplex communications over

a V.24, V.35, EIA-530, V.36/RS-449, or X.21 interface at speeds of

up to 2 Mbps per port, depending on the type of interface selected.

Ease of Use

No interface selection is required beyond connecting the appropriate

cable to the EiconCard P92. The intelligent controller on the card

detects which interfaces the cable supports and automatically

configures that port accordingly.

203086-1.FM5 Page 5 Friday, February 28, 1997 10:35 AM

1 2 3 4 5 6 7 8 9 10 ... 31 32

Keine Kommentare

Eicon Networks P92 Installationsanleitung Seite 5