
Chapter Ten: Other Configuration Tools DTMF interface
135
Loading new firmware via TFTP
To upload new firmware to the DIVA LAN ISDN Modem, use your TFTP client software to transfer the
firmware file. For example, under NT, you would issue the following command:
tftp -i 192.168.1.1 put NewImageFile image.elm
Where:
• 192.168.1.1 is the IP address of the DIVA LAN ISDN Modem.
• NewImageFile is the name of the most recent DIVA LAN ISDN Modem image file.
• image.elm is the target file name on the DIVA LAN ISDN Modem.
DTMF interface
The DIVA LAN ISDN Modem enables you to set certain parameters using a standard touch-tone telephone.
Prerequisites
• touch-tone analog phone
Local access
• Phone must be plugged into PHONE port 2.
• ISDN line must not be connected.
Remote access
• Not available.
How it works
Plug an analog phone into PHONE port 2.
• Each command starts and ends with a #.
• A short beep indicates that the command you entered was accepted.
• Continuous beeping indicates that the command you entered was rejected. Enter # to start a new command
and end the beeping.
Commands
The following commands are available.
Set primary ISDN telephone number
#TN1 ISDN number # (#861ISDN number #)
Example: #8614078#
Set second ISDN telephone number
#TN2 ISDN number # (#862 ISDN number #)
Example: #8624079#
Set ISDN switch type
• #STA# (#782#) Australia
• #STJ# (#785#) Japan
• #STE# (#783#) Euro-ISDN
Save configuration and reset
#SA# (#72#)
Kommentare zu diesen Handbüchern