Eicon Networks S52 Wartungshandbuch PDF herunterladen (Seite 31)

Dial-Up Networking and RAS Administration

page 31

9. In the Phone Number to Dial box, enter the phone number of the server.

If the server is configured to use subaddresses, you must specify the appropriate subaddresses under Phone

Number:, separated by the vertical stroke "|", (the pipe symbol, or press [Alt] and the digits [0], [1], [2]

and [4] on the numeric keypad).

For example, if the phone number is 071594066 SUB 41, you must enter 071594066|41.

If your connection protocol is something other than synchronous HDLC, you must specify which protocol is

used. This information can be attached to the server phone number, separated by the caret character "^".

For example, for an analog call, add "^MODEM" to the phone number of the server. For a call to GSM, add

"^GSM1", "^GSM2" or "^GSM3".

If your connection uses something other than a transfer rate of 64 kbps, you must specify which transfer

rate is used. This information can also be attached to the server phone number separated by the caret

character "^".

For example, for a call to some regions in the United States where a line, a switch, or a device only supports

a transfer rate of 56 kbps, add "^56K" to the server phone number. The "T1 RBS" switch type always uses

a transfer rate of 56 kbps. Therefore, you must add "^56K" for all outgoing calls if you use this switch type.

The required information can be found in the following table. The various parameters can also be entered

in combination.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 57 58

Keine Kommentare

Eicon Networks S52 Wartungshandbuch Seite 31