Eicon Networks ISDN NT1 Spezifikationen

www.eicon.comEiconcard C9x Familyfor PCI-Compatible Bus

10 Making an ISDN ConnectionEiconcard C91 S/T-interface:If your Eiconcard C91 has an S/T-interface, you need a separate NT1. Note You can order an NT

Termination 11TerminationThis section applies to S/T interface users in Australia and North America, and provides instructions to help set up terminat

12 TerminationMultiple ISDN DevicesIf the NT1 is connected to more than one ISDN device, follow the procedures below.75 meters or moreIf the connectio

Making a V.24 Connection 13Making a V.24 ConnectionThe Eiconcard C91 can make V.24 connections using standard V.24 cables. Table 1. Standard Interface

14 The V.24 DCE InterfaceThe V.24 DCE InterfaceA pin-out diagram for the V.24 DCE interface is shown in Figure 6. The signal definitions and names are

LED Functionality 15LED FunctionalityNote The Eiconcard C90 only has the V.24 port, the Eiconcard C91 has both the ISDN BRI port and V.24 port. ISDN (

16 Technical SpecificationsTechnical SpecificationsTechnical Data• PCI bus compatible (32-bit slot)Hardware Installation• Automatic configuration of i

International Regulatory Information 17International Regulatory InformationRegulatory Information for the USA:WARNING. Changes or modifications to thi

18 Regulatory Information for the USA:FCC Part 68 NoticeThis unit complies with Part 68 of the FCC rules. On the bottom of this equipment is a label t

Regulatory Information for Canada 19Regulatory Information for CanadaNOTICE: The Industry Canada label identifies certified equipment. This certificat

www.eicon.comFirst Edition (July 2001) 203-226-01Eicon, Eiconcard, and the Eicon logo are either trademarks or registered trademarks of Eicon Networks

20 Regulatory Information for EuropeRegulatory Information for Europe EU Declaration of ConformityEN: Eicon Networks Corporation declares that this eq

Regulatory Information for Europe 21Safety Status: SELVNo voltages within this equipment exceed SELV voltages. All interconnection points and ports ar

22 Regulatory information for AustraliaRegulatory information for Australia• This customer equipment shall only be installed in a PC that requires the

203-226-01

www.eicon.comTable of ContentsIntroduction ... 5About this Manual...

www.eicon.com

Introduction 5IntroductionThe Eiconcard C9x is a PCI Plug-and-Play (PnP) card that offers X.25 connectivity through a V.24 serial port at speeds of up

6 Installing the Eiconcard C9xInstalling the Eiconcard C9xFollow the steps below to install the Eiconcard C9x. If you want the Eiconcard C9x to be ava

Installing the Eiconcard C9x 7Figure 2. Inserting the Eiconcard C9x.e)Fasten the adapter with the screw (to ensure that the adapter is properly secure

8 Making an ISDN ConnectionMaking an ISDN ConnectionNote Only the Eiconcard C91 supports ISDN connections.After you have installed your Eiconcard C91,

Making an ISDN Connection 9Eiconcard C91 U-interface:If your Eiconcard C91 has a U-interface, the NT1 is integrated into the adapter, and you do not n